This is the E-flite 60-Amp Pro Switch-Mode BEC Brushless ESC V2. This ESC is high-quality, efficient, sensorless and has an integrated Switch-Mode BEC. It is capable of up to 60 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage. It has advanced programmable features such as low voltage cutoff, braking, timing and throttle input range.
Features:
- Up to 60 amps continuous current with proper air flow and 75 amps burst current (15 seconds)
- 5A continuous current, 5V switch-mode BEC circuit (proper cooling and airflow required)
- Stronger BEC for support of most 3-axis stabilization systems
- Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
- 3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
- Finned heat sinks
- Programmable motor braking
- Safe power-arm mode prevents accidental starts
- Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
- Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
- Programmable soft start for helis and airplanes
- Auto motor shut down if signal is lost or there is interference
- Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors
- Utilizes new smaller MOSFET technology to minimize weight
- Radio system power on/off switch
- Pre-wired connectors—E-flite EC3 connector on battery input and 3.5mm gold bullet connectors on motor output leads
Specifications:
Continuous Maximum Current: 60A
Input Connector Types: 13 AWG with E-flite® EC3™ connector
Output Connector Types: 13 AWG with 3.5mm gold bullet connectors
Momentary Peak Current: 15 sec @ 75A with proper cooling air flow
Length: 2.85 in (73.0mm)
Width: 1.30 in (33.0mm)
Height: 0.61 in (15.5mm)
Weight: 2.65 oz (75.0 g)
Cells w/BEC: 3–6S Li-Po or 9–18 Ni-MH/Ni-Cd
